Qlogic QME8242 Guia Del Usuario página 122

iBFT Boot Setup: QLogic QME8242 Mezzanine Card User's Guide
Figure 12. Configuring Initiator Settings for IPv6 (Dynamic)
7. Press the <Esc> key to return to the Adapter Settings menu.
8. On the Adapter Settings menu, select Primary Target Settings and then press <Enter>.
9. Under Target Settings, configure the following, as shown in
a. If the Target Param From DHCP was disabled in
and Boot LUN to the appropriate settings for the target setup.
b. (Optional) Specify the CHAP Type as one of the following:
None to disable CHAP
One-Way for a target-authenticating initiator
Mutual to enable both the target and initiator to authenticate each other
c. (Optional) Configure the Target CHAP Name and Target CHAP Secret as needed.
Figure 13. Configuring Target Settings for IPv6 (Dynamic)
10. Press the <Esc> key and save the settings.
11. Reboot the system.
file:///T|/htdocs/NETWORK/QLogic/71922/en/ibft.htm[9/26/2012 4:26:32 PM]
All manuals and user guides at all-guides.com
step
Figure 13:
6, set the Target Name, Target IP Address, Target Port,