Qlogic QME8242 Guia Del Usuario página 86

User Diagnostics for Windows NIC Driver Management Applications: QLogic QME8242 Mezzanine Card User's Guide
qaucli -nic [options]
netscli [options]
qaucli iscsi [options]
iscli [options]
qaucli -fc [options]
scli [options]
Diagnostic help commands, and command options available for each specific protocol, are available by specifying -h to the
protocol, as shown in Table
Table 3. Windows QConvergeConsole CLI—Getting Help
Command
-h
qaucli -pr nic -h
qaucli -pr fc -h
qaucli -pr iscsi -h
qaucli -npar -h
Table 4 lists miscellaneous Windows diagnostics commands.
Table 4. Windows QConvergeConsole CLI—Miscellaneous Commands
Command
qaucli -v
qaucli -h
Table 5 lists the Windows CLI diagnostic test commands. Note that while running these tests, network traffic is interrupted.
Table 5. Windows QConvergeConsole CLI—Diagnostic Test Commands
Command Description
-i Specifies the interface type (NX_NIC, NX_NIC1, and so on)
--interface
-a Perform all test, regardless of default
--all
-D Perform only default test
--default
-R Test all control registers (default)
--CRegs
-I Test interrupt mechanism (default)
--IRQS
-L Internal loopback test (default)
--IntLB
-H Hardware test (default)
--Hw
-S Link status test (default)
file:///T|/htdocs/NETWORK/QLogic/71922/en/diag_win.htm[9/26/2012 4:26:06 PM]
All manuals and user guides at all-guides.com
Use NIC legacy command line
Use NIC legacy command line
Use iSCSI legacy command line
Use iSCSI legacy command line
Use Fibre Channel legacy command line
Use Fibre Channel legacy command line
3.
Description
Print usage of a specific adapter type, and then exit
Print NIC protocol usage, and then exit
Print Fibre Channel and FCoE protocol usage, and then
exit
Print iSCSI protocol usage, and then exit
Print NPAR commands usage, and then exit
Description
Print version number, and then exit
Print usage, and then exit