Publicidad
Idiomas disponibles
Idiomas disponibles
10
UK
Thank you for choosing GIBIDI.
PLEASE READ CAREFULLY THIS MANUAL BEFORE PROCEEDING WITH THE INSTALLATION.
WARNING: follow these personal safety instructions very carefully. Save this manual for future reference.
GI.BI.DI. S.r.l.
reserves the right to modify the technical data without prior notice, depending on the product
development.
DISPOSAL: GI.BI.DI. advises recycling the plastic components and disposing of them at special
authorised centres for electronic components, protecting the environment from polluting substances.
INSTALLATION WARNINGS
• Before proceeding with the installation, it is necessary to fit a magnetothermal and differential switch of 10A
max. upstream of the system. The switch must guarantee an omnipolar separation of the contacts with an
opening distance of at least 3 mm.
• To prevent possible interferences, differentiate and always keep the power cables (min. cross-section 1,5mm²)
separate from the signal cables (min. cross-section 0,5mm²).
• Make the connections referring to the following tables and to the attached screen-print. Be extremely careful to
connect in series all the devices that are connected to the same N.C. (normally closed) input and in parallel all
the devices that share the same N.O. (normally open) input.
• The inputs normally closed (PHOTOCELL) must be jumpered if not used.
• An incorrect installation or an improper use of the product may compromise the safety of the system.
• Keep all the materials contained in the packaging away from children, since they pose a potential risk.
• The manufacturer declines any responsibility for improper functioning of the automated device if the original
components and accessories suitable for the specific application are not used.
• After the installation, always carefully check the proper functioning of the system and the devices used.
• This instruction manual addresses persons qualified for installation of "live equipment". Therefore good technical
knowledge and professional practice, in compliance with the regulations in force, are required.
• Maintenance must be carried out by qualified personnel.
• Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
• This control unit may only be used for the purpose for which it was designed.
• Check the aim of the final use and make sure that all safety measures are taken.
• The use of the products for purposes different from the intended use has not been tested by the manufacturer,
therefore any work is carried out on full responsibility of the installer.
• Mark the automated device with visible warning plates.
• Warn the user that children or animals must not play or stand near the gate.
• Appropriately protect the danger points (for example using a sensitive frame).
SR2
Publicidad
