Installation Warnings; Warnings For The User - GiBiDi SC24 Instrucciones Para La Instalación

SC24

3 - INSTALLATION WARNINGS

• Before proceeding with the installation, it is necessary to fit a magnetothermal and differential switch of
10A max. upstream of the system. The switch must guarantee an omnipolar separation of the contacts, with
an opening distance of at least 3 mm
• To prevent possibile interferences, differentiate and always keep the power cables (min. cross-section 1,5mm²)
separate from the signal cables (min. cross-section 0,5mm²)
• Make the connections referring to the following tables and to the attached screen-print. Be extremely careful to
connect in series all the devices that are connected to the same N.C. (normally closed) input and in parallel all
the devices that share the same N.O. (normally open) input. An incorrect installation or an improper use of the
product may compromise the safety of the system
• K eep all the materials contained in the packaging away from children, since they pose a potential risk
• The manufacturer declines all responsibility for improper functioning of the automated device if the original
components and accessories suitable for the specific application are not used
• After the installation, always carefully check the proper functioning of the system and the devices used
• This instruction manual addresses persons qualified for installation of "live equipment". Therefore good
technical knowledge and professional practice in compliance with the regulations in force are required
• Maintenance must be carried out by qualified personnel
• Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains
• This control unit may only be used for the purpose for which it was designed
• Check the aim of the final use and make sure that all safety measures are taken
The use of the products for purposes different from the intended use has not been tested by the manufacturer,
•
therefore any work is carried out on full responsibility of the installer
• Mark the automated device with visible warning plates
• Warn the user that children or animals must not play or stand around near the gate
• Appropriately protect the danger points (for example using a sensitive frame

4 - WARNINGS FOR THE USER

In the event of an operating fault or failure, cut the power upstream of the control unit and call the technical
service. Periodically check the functioning of the safety devices. Any repairs must be carried out by specialised
personnel using original and certified materials.
The product is not to be used by children or people with physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given instruction. Do not touch the card for adjustments
and/or maintenance.
.
.
WARNING: IMPORTANT SAFETY INSTRUCTIONS.
It is important for the safety of persons to follow these instructions.
Keep this instruction manual.
.
.
.
.
.
.
).
.
.
.
.
.
.
11
UK