Kichler 56 ICON Manual De Instrucciones página 20

INSTALLING THE COOL TOUCH
CONTROL SYSTEM WALL PLATE
Select a location to install the Wall Control System Transmitter and
Wall Plate.
WARNING: All wiring must be in accordance with the National
Electrical Code and local electrical codes. Electrical installation
should be performed by a qualified licensed electrician.
Select a location to install your CoolTouch™ Control System
Transmitter. You can replace an existing wall switch or, install the
transmitter on ANY flat surface.
Option 1: Install the control system using an existing wall switch
outlet box. Make sure the electrical power is TURNED OFF at the
main panel before continuing.
NOTE: Switch installation must comply with all local and national
electric codes.
Step 1. Remove the existing wall plate and the old switch from the
wall outlet box. Wire nut the BLACK leads (hot) together and push
back inside the outlet box. (Fig. 28)
Step 2. Install the metal plate and CoolTouch™ wall plate to the
existing wall outlet box with 4 screws provided. Then place the two
plastic plugs into the wall plate. (Fig. 29)
Option 2: Install the control system on ANY flat surface.
Select the desired location and use the CoolTouch™ wall plate to
mark the location for the mounting holes. Use the dry wall anchors
and/or screws provided and finish the installation.
20
| KICHLER.COM
TM
Outlet box
Outlet box
Metal plate
CoolTouch
Screws
Switch
Wall plate
Fig. 28
wall plate
™
Plastic plugs
Screws
Fig. 29