Kichler 56 ICON Manual De Instrucciones página 9

HANGING THE FAN (continued)
Step 5. Remove the hanger ball from the downrod assembly by
loosening the set screw, unscrewing and removing the cross pin and
unscrewing the ball off the rod. (Fig. 8)
Step 6. Loosen the two set screws and remove the hitch pin and
retaining clip from the coupling on top of the motor assembly. (Fig. 9)
Step 7. Carefully feed the electrical lead wires from the fan up
through the downrod. Thread the downrod into the coupling until the
hitch pin holes align.
Next, replace the hitch pin and retaining clip. Tighten both set screws.
(Fig. 9)
Cross pin
Hanger ball
Downrod
Supply wire &
Safety cable
Downrod
Coupling
Set screws
Set screws
Retaining
Hitch pin
clip
Fig. 8
Fig. 9
9
56" ICON |