Publicidad
All manuals and user guides at all-guides.com
10.5. Replace the spindles of
the round fan control
Note!
The round fan control (R) is
fixed to the ideal value with a
lock washer cannot be adjusted.
However, the components can be
replaced during maintenance.
Dismantle spindle
■ Unscrew the countersunk screw
[13-4].
■ Remove the control knob [13-3].
■ Unscrew the spindle [13-2] using the
SATA universal spanner.
■ Remove the lock washer [13-1].
Mount new spindle
■ Position the lock washer [13-1].
■ Screw the spindle [13-2] in using the
SATA universal spanner.
■ Position the control knob [13-3].
■ Screw in the countersunk screw [13-
4] by hand. Secure with Loctite 242.
10.6. Replace the scale on
the gun body
Remove the scale
■ Unscrew the screw [14-4].
■ Remove the flat washer [14-3].
■ Remove the scale [14-2].
■ Remove the spacer [14-1].
Mount new scale
■ Position the spacer [14-1].
■ Position the scale [14-2] with the
marks to the outside.
■ Position the flat washer [14-3].
■ Screw in the screw [14-4] by hand.
SATA LAB Automatic Gun Operating Instructions
10.7. Replacing the control
If the seal or sleeve of the control
piston is damaged, it is possible
for air to leak from the material
flow control [1-4] or from the reg-
ulating cap [1-2].
→ Replace seal or sleeve imme-
diately.
The sealing surface of the control
piston is very sensitive and dam-
ages easily.
→ Do not chuck the control piston
at the sealing surface.
Dismantle components
■ Unscrew the regulating cap [15-1].
■ Remove washer [15-2] and spring
[15-3].
■ Unscrew the end cap [15-4].
■ Remove both springs [15-5], [15-6].
■ Remove paint needle [15-7].
■ Pull the control piston [15-8] out using
flat pliers.
■ Fix the control piston [16-7] using the
SATA universal spanner.
■ Unscrew hex socket screw (spanner
size 4) [16-9].
■ Remove O-ring [16-8].
■ Unscrew banjo screw (spanner size
14) [16-1].
■ Remove washer [16-2] and sleeve
[16-3].
■ Take the compression spring [16-4],
washer [16-5] and seal [16-6] out of
the control piston.
■ Check parts for damage and soiling,
clean or replace if necessary.
piston components
Attention!
EN
109
Publicidad
