Publicidad
Idiomas disponibles
Idiomas disponibles
Displaying Data from Multiple Sensors, Automatic Cycling through Values from
Connected Sensors
Press the
button repeatedly to display data from all connected sensors on the weather station,
one by one.
You can also activate cycling through data from all connected sensors:
1. turning on cycling
Repeatedly press the
button until the display shows the
Data from all 3 sensors will be shown automatically and repeatedly one after another.
2. turning off cycling
Repeatedly press the
button until the
Radio Controlled Clock (DCF77)
The wireless temperature/humidity/wind sensor will automatically start searching for DCF77 (here-
inafter referred to as DCF) signal for 5 minutes after pairing with the weather station; the
flashing. (The DCF sensor is located in the temperature/humidity/wind sensor).
Signal detected – the
icon stops flashing and the current time will be displayed with the DCF icon
Signal not detected – DCF icon
2:00 and 3:00 am.
You can also activate search for DCF signal manually.
Long-press the WAVE button located in the battery compartment of the temperature/humidity/
wind sensor.
The sensor will start searching for DCF signal. To end the search, long-press the WAVE button again.
Note: If the weather station detects DCF signal but the current time on the display is incorrect (e.g.
shifted ±1 hour), you must always set the correct time zone for the country where you are using the
station, see Manual Settings.
In standard conditions (at safe distance from sources of interference, such as TV sets or computer
monitors), the reception of time signal takes several minutes. If the weather station does not detect
the signal, follow these steps:
1. Move the weather station to another location and try to detect DCF signal again.
2. Check the distance of the clock from sources of interference (computer monitors or television
sets). It should be at least 1.5 to 2 m during the reception of signal.
3. When receiving DCF signal, do not place the weather station in the proximity of metal doors, win-
dow frames and other metal structures or objects (washing machines, dryers, refrigerators etc.).
4. In reinforced concrete structures (cellars, high-rise buildings etc.), the DCF signal reception is
weaker, depending on the conditions. In extreme cases, place the weather station close to a
window toward the transmitter.
Reception of the DCF 77 radio signal is affected by the following factors:
• thick walls and insulation, basements and cellars,
• inadequate local geographical conditions (these are difficult to assess in advance),
• atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers, located near the DCF radio receiver.
Manual Settings
All changes in values are made using buttons
After setting the desired value and not pressing any other buttons, the set values will automatically
save and the display will switch to the main screen.
Setting Time, Date and Time Zone
1. Short-press the
button
2. Press the
button for 3 seconds and use the
time zone, calendar language (ENG, GER, FRE, ITA, DUT, SPA, DAN), year, date format, month,
day, 12/24 h time format, hour, minute, second.
3. Confirm the set value by pressing the
icon disappears.
will not be displayed. DCF signal will be synchronised daily between
and
.
and
button; holding the arrow keys speeds up settings.
6
icon.
buttons to set the following values:
icon is
.
Publicidad
