Power Button; Reset Button - Geutebruck G-ST 500+ Manual De Instrucciones

Idiomas disponibles

G-ST 500+

8 System Status LED

There are four LED indicators on the front panel: PWR, HDD, WDT and IGN.

The descriptions of these four LEDs are listed in the following table.

Indicator

IGN

WDT

HDD

PWR

9 Power Button

The power button is a non-latched switch for ATX mode on/off operation. To turn on the

G-ST 500, press the power button and the PWR LED should light-up green. To turn off the

G-ST 500, issuing a shutdown command in OS is preferred, or you can simply press the

power button. To force shutdown when the system freezes, press and hold the power but-

ton for 5 seconds. Please note that there is a 5-second interval between on/off operations

(i.e. once turning off the system, there is a 5-second wait before you can power-on the sys-

tem).

The reset button is used to manually reset the system in case of system halt or malfunc-

tion. To avoid unexpected reset, the button is purposely placed behind the panel.

To reset, please use a pin-like object (eg. tip of a pen) to access the reset button.

Color

Green

Ignition signal indicator, lid when IGN is high (12V/ 24V).

Yellow

Watchdog timer indicator, flashing when WDT is active

Red

Hard drive indicator, flashing when SATA drive is active

Green

Power indictor, lid when system is on

Description

Back to the

table of contents

Tabla de Contenido