Integrating The Device Into The Network - Geutebruck G-ST 500+ Manual De Instrucciones

G-ST 500+
To modify the language displayed in Windows, follow these steps:


Double click on the Language icon and click "Install display languages" to open the selec-
1.
tion menu.
2. Select a language and click "Next". The corresponding language pack is installed.
3. Open the Region and Language options, by right clicking Start, Control Panel and then Lan-
guage.
4. Click Add a Language to access the selection menu. Select your language and click "Add".
5. By clicking on your country language and on Options you access the activation menu for the
primary language.
6. Activate your language by clicking "Make this the primary language" and follow the instruc-
tions.

Integrating the device into the network

It is best to have the following work performed by an administrator:
1. Assign the G-ST the intended IP address in order to integrate it into the network. Manual as-
signment of IP addresses is performed using the settings of the network card of the device.
2. Using the console command PING, check whether the device was integrated correctly into
the network. You start the command window using right klick on Start  left klick on Com-
mand prompt  enter PING + IP adress.
In general, when assigning an IP address, make sure that the assigned address is
in fact available and not already assigned to another network component.
Add the desired language.
Define the desired languages as the primary language.
37
Back to the
table of contents