Publicidad
Idiomas disponibles
Idiomas disponibles
G-ST 500+
Installing a Half Size mini PCIe Module
If you want to install a halfsize module (e.g. WIFI
card), you will need the following mounting
adapters and accessories:
- 1 x 4.94437 Metal adapt half size MiniPCIe
- 2 x 4.94421 RF-Interface Cable
'IPEX U.FL' to 'SMA'
DC Power Connection
The system uses a 3-pin pluggable terminal block to accept 8~35V DC power input. It is a reli-
able, convenient and easy method to directly wire cables to the DC power connector.
The pluggable terminal block is also used to accept ignition signal To connect DC power via the
3-pin pluggable terminal block, please refer to the procedures described below.
1. Before connecting the cables, please make sure the DC power supply is unplugged!
2. Take the 3-pin pluggable terminal block out of the accessory box. The terminal block fits the
wires with a gauge of 12~24 AWG.
3. Carefully identify the positive and negative contacts of your DC
power supply and the pluggable terminal block. The polarities between
DC power supply and terminal block must be positive (+) to positive (+)
and ground (GND) to ground (GND).
4. Insert the wires to the matching pluggable terminal block contacts and tighten clamping
screws using a Philips screwdriver.
5. Plug in the terminal plug into the 3-pin pluggable terminal block on the system enclosure and
secure the plug using a flat-head screwdriver.
WARNING
The system accepts 8~35 VDC when using terminal block for DC input. Please make
sure the voltage and polarity of DC power is correct before you connect and power
on the system.
Supplying a voltage over 35V or incorrect polarity will damage the G-ST 500
30
Back to the
table of contents
Publicidad
