Mounting Of Your G-St 500 - Geutebruck G-ST 500+ Manual De Instrucciones

G-ST 500+

Mounting of your G-ST 500+

G-ST 500 series is shipped with dedicated wall mount/ anti-vibration for in-vehicle installation.
The patented anti-vibration damping bracket offers superior vibration resistance (up to 1Grm
with HDD and 5Grms with SSD, operating). To install the bracket, please refer to the following
installation procedure.
NOTE
You will need to remove the four (4) rubber stands at the bottom of the enclosure if they
have been attached.
Mount your G-ST with Dedicated Damping Brackets
1. Take the anti-vibration damping bracket, ten (10) M4 step screws and six (6) shock-absor-
bing grommets from the accessory box. There are four (4) shock-absorbing grommets (indica-
ted in red) pre-installed on the bracket.
2. Insert the shock-absorbing grommets (indicated in blue) into the brackets shown in the illust-
ration below and fix the anti-vibration damping bracket to the system using four (4) M4 step
screws.
The dammping bracket performs best when the system is installed horizontally.
3. Once the bracket has been secured onto the system, place the system at the desired loca-
tion on a flat surface, secure it with the other six (6) M4 screws.
31
Back to the
table of contents