Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 4: Save and Exit
EXIT
A Save and Exit must be performed after the above settings are
completed. If this is not done, the information will revert to its prior
settings.
1.
From the User Setup menu, use the UNWRAPPED and WRAPPED
buttons to scroll to Save and Exit.
2.
Select it by pressing the RUBBER AND PLASTIC button.
3.
The LCD will display time and date information and a sequence of
messages (see images after STEP 5 below):
STEP 5: Connecting the SciCan Data Logger
1.
Ensure that both the STATIM unit and the SciCan Data Logger are off.
2.
Connect the SciCan Data Logger to the STATIM
unit by using the serial cable.
3.
Power up the SciCan Data Logger.
4.
Power up the STATIM unit.
5.
The LCD will display the following sequence of messages:
6.
Insert USB Flash Drive or SD memory card.
7.
After a few seconds the LCD will display the
following sequence of messages:
SciCan Ltd.
The Communication Port
HH:MM DD/MM/YYYY
SELECT A CYCLE
HH:MM DD/MM/YYYY
MSD NOT CONNECTED
HH:MM DD/MM/YYYY
INSERT MSD/FLASH
HH:MM DD/MM/YYYY
SELECT A CYCLE
HH:MM DD/MM/YYYY
MSD/FLASH DETECTED
HH:MM DD/MM/YYYY
SAFELY REMOVE MSD
23
STATIM 2000/5000 Cassette Autoclave Operator Manual
Publicidad
