Publicidad
Idiomas disponibles
Idiomas disponibles
7. Internal Printer
(Not on all models)
7.1 Installing Paper on the Internal Printer
Use only paper approved for use with the optional internal printer on the
STATIM 5000. The use of any other paper will damage the printer and will
void the warranty. Thermal paper is available from your dealer (SciCan
order no. 01-101657S).
Do not operate the printer without paper. If you run out of thermal paper,
or if you do not wish to use the printer, turn it OFF.
Never pull the paper backwards through the printer. This will damage the
printer mechanism.
To install the paper into the printer, follow these steps:
1.
Power the STATIM 5000
2.
Open the printer door
3.
Power the printer
4.
Unroll some paper from the thermal paper roll
using the paper cutting template included with each box.
5.
Move the paper roll arm
roll
(3)
then carefully insert it into the paper feed slot
If the paper does not feed from the top, the heat sensitive side of the
paper will not be in contact with the print head and the printer will not
print.
6.
With one hand, continue to gently feed the paper strip into the paper
feed slot. With the other hand, press the paper advance button
until the paper feeds by itself.
Keep the paper straight when feeding it into the printer or it may jam. Do
not force the paper into the slot! If the paper will not feed into the slot,
pre-cut the end of the roll again and reload the paper.
7.
Continue to press the paper advance button
through the paper exit slot on the front of the printer. Then, move the
paper roll
the printer door (1). The printer is now ready to operate.
When you see a red line on one side of the paper, it is time to replace the
roll.
If a paper jam occurs, and the paper cannot be removed by pressing the
paper advance button
printer.
Never put a utensil or tool into the paper exit slot.
For full instructions on how to remove paper jams,
see Section 7.2 Removing Internal Printer Paper Jams.
To replace the paper roll
1.
With scissors, cut the paper between the roll and the paper feed slot (5).
2.
Remove the roll from the arm and discard the unused portion.
3.
Press the paper advance button
the printer out of the slot at the front of the printer.
4.
Install the new thermal paper roll by following the instructions described
in this section.
SciCan Ltd.
Internal Printer
.
ON
by pushing on the top half of the door.
(1)
ON
(2).
into the loading position. Place the paper
(4)
on the arm so the paper strip feeds from the top of the roll and
and arm into the operating position and close
(3)
, do not pull the paper backwards through the
(6)
, follow these steps:
(3)
(6)
and trim the corners
(3)
until it stops.
(5)
until the paper feeds
(6)
to feed the paper that remains in
25
5
2
4
3
4
6
(6)
5
2
6
STATIM 2000/5000 Cassette Autoclave Operator Manual
1
Figure 15 a
Figure 15 b
3
Figure 15 c
Publicidad
