Publicidad
Idiomas disponibles
Idiomas disponibles
3.9 Adjusting the Cycle Drying Time
The STATIM has preset dryng time of 10 minutes for Unwrapped cycles
and 30 minutes for Wrapped cycles. You can adjust the time between 5
to 60 minutes for Unwrapped cycles and 5 to 60 minutes for Wrapped
cycles.
1.
Power the STATIM OFF.
2.
While pressing and holding the STOP cycle
button, power the STATIM ON.
3.
Using the Wrapped and Unwrapped cycle buttons scroll to DRYING
UNWRAPPED or DRYING WRAPPED and
press the RUBBER/PLASTIC button.
4.
Using the Wrapped and Unwrapped cycle buttons, scroll to the desired
drying time and select it by pressing the RUBBER/PLASTIC button.
(Unwrapped Drying Time applies to Unwrapped,
Heavy Duty, and Rubber/Plastic cycles).
5.
To save changes and return to the regular operating mode, press the
STOP button.
3.10 Preparing Unit for Use
Once the unit is installed and before any instruments are sterilized, run two
Wrapped cycles (see Section 4.8 Running a Cycle). Remove the cassette
once it has cooled. Clean the top (lid) and bottom (tray) sections using a
soft cloth to wipe the inside surfaces and then rinse thoroughly with tap
water. Once the cassette is clean and dry, coat the inside surfaces with
STAT-DRI.
3.11 Shipping the Unit
Before you move the unit, you will need to drain the reservoir. To do so,
follow these steps:
1.
Place a water container below the unit.
2.
Use the drain tube
water container.
3.
Remove any remaining water from the reservoir with a non-linting,
absorbant towel.
4.
Screw-in the three leveler feet
5.
Repack the unit in the original packing materials and include all
accessories originally included with the unit.
6.
Specify heated and insured shipping.
SciCan Ltd.
Installation
to empty the contents of the reservoir into the
(5)
found underneath the unit.
(6)
8
STATIM 2000/5000 Cassette Autoclave Operator Manual
> DRYING UNWRAPPED
DRYING WRAPPED
> DRYING UNWRAPPED
10min
or
> DRYING WRAPPED
30min
4
5
6
6
6
Figure 7
Publicidad
