Stihl TS 700 Manual De Instrucciones página 11

absolutely sure that the cutting wheel is
clear of you and all other obstructions
and objects, including the ground. When
the engine starts at starting-throttle,
engine speed will be fast enough for the
clutch to engage the belt pulley and turn
the wheel. Never attempt to start the cut-
off machine when the abrasive wheel is
in a cut.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting throttle
lock and allow the engine to slow down
to idle.
WARNING
When you pull the starter grip, do not
wrap the starter rope around your hand.
Do not allow the grip to snap back, but
guide the starter rope slowly back to
permit the rope to rewind properly.
Failure to follow this procedure may
result in injuries to hand or fingers and
may damage the starter mechanism.
Important Adjustments
At correct idle speed, the wheel should
not turn. For directions to adjust idle
speed, see the appropriate section of
your instruction manual.
WARNING
Do not use a cut-off machine with
incorrect idle speed adjustment. The
rotating wheel may cause injury. If you
cannot obtain the correct setting, have
your STIHL dealer check your cut-off
machine and make proper adjustments
or repairs.
TS 700, TS 800
Working Conditions
Operate the cut-off machine under good
visibility and daylight conditions only.
Wearing of hearing protection reduces
sound perception. Be alert not to miss
voice signals from co-workers. Keep
within calling distance to other persons
who may assist in case of emergency.
WARNING
As soon as the engine is
running, this product gen-
erates toxic exhaust
fumes containing chemi-
cals, such as unburned
hydrocarbons (including
benzene) and carbon
monoxide, that are
known to cause respira-
tory problems, cancer,
birth defects, or other
reproductive harm. Some
of the gases (e.g. carbon
monoxide) may be color-
less and odorless. To
reduce the risk of serious
or fatal injury/illness from
inhaling toxic fumes,
never run the machine
indoors or in poorly venti-
lated locations. Ensure
proper ventilation when
working in trenches or
other confined areas.
WARNING
Use of this product to cut masonry,
concrete, metal and other materials can
generate dust and fumes containing
chemicals known to cause serious or
fatal injury or illness, such as respiratory
disease, cancer, birth defects or other
reproductive harm. If you are unfamiliar
with the risks associated with the
particular material being cut, review the
material safety data sheet and/or consult
your employer, the material
manufacturer/supplier, governmental
agencies such as OSHA and NIOSH
and other sources on hazardous
materials. California and some other
authorities, for instance, have published
lists of substances known to cause
cancer, reproductive toxicity, etc.
Control dust and fumes at the source
where possible.
In this regard use good work practices
and follow the recommendations of the
manufacturer/supplier, OSHA/NIOSH,
and occupational and trade
associations. A water attachment kit is
provided with your cut-off machine and
should be used to reduce dust whenever
wet cutting is feasible. For dust
suppression purposes, the flow rate
should be at least 0.6 liters (20 fl.oz) of
water per minute. If wet cutting at the
recommended flow rate is not utilized,
the operator and any bystanders should
always wear a respirator approved by
NIOSH/MSHA for the material being cut.
See the section on "Respiratory
Protection" in the chapter "Sample
Applications" in the instruction manual.
Even if wet cutting at the recommended
flow rate, an operator who is actively
cutting for more than two hours in one
day should wear at least a NIOSH-
approved disposable respirator. Consult
and follow any federal, state or local
laws or regulations with respect to dry
and wet cutting.
English
9