Engine Management; Adjusting The Carburetor - Stihl TS 700 Manual De Instrucciones

Ocultar thumbs Ver también para TS 700:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Remove screws (3)
N
Remove filter housing (4)
N
6
5
Pull main filter (5) out of the filter
N
housing
Set choke lever to c
N
Remove the auxiliary filter (6) from
N
filter base – ensuring that dirt does
not enter the intake area
Clean the filter area
N
Remount main filter and new
N
auxiliary filter with the remaining
filter components
Refit filter cover
N
Tighten down the locking screw
N
Always use original STIHL air filters. The
high quality of these parts will ensure
trouble free operation, a long service life
for the engine and extremely long filter
life.
TS 700, TS 800

Engine Management

Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.

Adjusting the Carburetor

Basic information
The ignition system of this cut-off
machine is equipped with an electronic
maximum speed limiter. The maximum
speed cannot be increased beyond a
specified limit.
The carburetor is equipped with a
factory-installed standard setting.
The carburetor has been adjusted for
optimum performance and fuel
efficiency in all operating states.
Preparing the machine
Switching off the engine
N
Check the air filter – clean or replace
N
it if necessary
Check the spark arresting screen in
N
the muffler (present only in some
countries) – clean or replace it if
necessary
English
37

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ts 800

Tabla de contenido