Fitting / Replacing An Abrasive Wheel - Stihl TS 700 Manual De Instrucciones

Fitting / replacing an abrasive
wheel
The engine must be switched off for
fitting or replacement – set Master
Control lever to STOP or 0.
Blocking the shaft
1
Slide the locking pin (1) through the
N
bore in the V-belt guard
Turn the shaft with the combination
N
wrench until the locking pin (1)
engages in a bore behind the guard
TS 700, TS 800
Removing an abrasive wheel
Use the combination wrench to
N
loosen and remove the hexagon
head screw (2)
Remove the front thrust washer (3)
N
from the shaft together with the
abrasive wheel
Fitting an abrasive wheel
4
Fit the new abrasive wheel (4)
N
WARNING
Note the arrows indicating the direction
of rotation on diamond abrasive wheels.
Fit the front thrust washer (3). The
N
catches of the front thrust
washer (3) must engage in the shaft
grooves.
Screw in the hexagon bolt and
N
tighten it with the combination
wrench – if using a torque wrench,
refer to the "Specifications" for the
tightening torque
Draw the locking pin out of the V-
N
belt guard
English
31