Stihl TS 700 Manual De Instrucciones página 31

Connecting the water connection
3
1
2
1
Insert the longer banjo bolt (1)
N
through the connector (2) of the
water attachment – observe the
position of the connector
Insert the square nut into the guide
N
in the guard and hold it in place
Fit the support with the longer banjo
N
bolt on the adjusting lever (3) –
screw in the banjo bolt and tighten
with the combination wrench
TS 700, TS 800
Checking the adjustment range of the
guard
Rotate the guard forwards and
N
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
"Tensioning the V-belt".
Inboard mounting (TS 800)
Disassemble the abrasive wheel
N
(see "Fitting / replacing an abrasive
wheel")
Remove the water attachment
N
Remove the adjusting lever
N
Slacken the V-belt
N
Remove the V-belt guard
N
Remove "support with guard"
N
Remove the sealing plug
N
Preparing the "support with guard" for
inboard mounting
Unscrew the stop pin (1)
N
Insert both sealing plugs (2) – on the
N
opposite side as well
A
2
Turn the guard so that it is in the
N
position shown (see picture)
Screw in and tighten the stop pin (1)
N
Install the adjusting lever
N
Mount "support with guard" – guard
N
on the inboard side
Install the V-belt guard
N
Connect the water connection
N
English
2 2
1
1
29