Assembling The Bearing And Guard - Stihl TS 700 Manual De Instrucciones

English
Assembling the bearing and
guard
The "support with guard" is mounted on
the inboard side by the manufacturer.
The "support with guard" can also be
mounted on the outboard side
depending on requirements.
Assembly on the inboard side is
recommended for freehand cutting on
account of the better balance.
Outboard mounting (TS 700)
Disassemble the abrasive wheel
N
(see "Fitting / replacing an abrasive
wheel")
Removing the water attachment
1
2
Unscrew the banjo bolt (1) with the
N
combination wrench – in the
process, remove the square nut
from the inside of the guard from the
guide
Remove the water hose (2) with
N
connector from the adjusting
lever (3)
24
Removing the adjusting lever
3
Unscrew the banjo bolt (1) with the
N
combination wrench and remove it
together with the seal – in the
process, remove the square nut
from the inside of the guard from the
guide
Unscrew the screw (2)
N
Turn the adjusting lever (3) upwards
N
and remove
3
1
2
1
Slackening the V-belt
1
1
2
To relax the poly V-belt, loosen the
N
nuts (1) – do not unscrew the
nuts (1) from the studs
Turn the tensioning nut (2)
N
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
Unscrew nuts (1) from the studs –
N
nuts (1) are fastened to the belt
guard so that they are secured
against loss
TS 700, TS 800
1