Rewind Starter
To help prolong the wear life of the
starter rope, observe the following
points:
Pull the starter rope only in the
N
direction specified.
Do not pull the rope over the edge of
N
the guide bushing.
Do not pull out the rope more than
N
specified.
Do not allow the starter grip to snap
N
back, guide it back into the housing
slowly – see chapter on "Starting /
Stopping the Engine."
Have a damaged starter rope replaced
by your dealer before it breaks
completely. STIHL recommends that
you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
TS 700, TS 800
Replacing the V-belt
4
2
6
1
5
6
6
The arrow on the tensioning nut (1)
N
must point to 0 – to this end, turn the
tensioning nut (1) with the
combination wrench
counterclockwise –
approx. 1/4 turn, as far as
possible = 0
Unscrew the nuts (2) from the studs
N
Remove the V-belt guard (3) and
N
remove the V-belt from the front
pulley
Remove the "support with guard".
N
Remove the hose (4) from the guide
N
of the starter cover (5)
Remove the screws (6) from the
N
starter cover
Remove the starter cover
N
Remove the defective V-belt from
N
the cast arm
8
3
Carefully fit a new poly V-belt (7) in
N
the cast arm and insert it in the front
poly V-belt pulley (8) on the engine
Fit the starter cover
N
Position the "support with guard"
N
against the cast arm
Fit the poly V-belt in the front poly V-
N
belt pulley (9)
Position belt guard
N
Align the studs in the support with
N
the nuts in the V-belt guard
Screw the nuts onto the studs – do
N
not tighten them yet
Place hose in the guide of the
N
starter cover
Continue as described in the chapter
"Tensioning the V-belt".
English
7
9
41