Stihl TS 700 Manual De Instrucciones página 12

English
WARNING
Cutting masonry, concrete and other
materials with silica in their composition
may give off dust containing crystalline
silica. Silica is a basic component of
sand, quartz, brick clay, granite and
numerous other minerals and rocks.
Repeated and/or substantial inhalation
of airborne crystalline silica can cause
serious or fatal respiratory diseases,
including silicosis. In addition, California
and some other authorities have listed
respirable crystalline silica as a
substance known to cause cancer.
When cutting such materials, always
follow the respiratory precautions
mentioned above.
WARNING
Breathing asbestos dust is dangerous
and can cause severe or fatal injury,
respiratory illness or cancer. The use
and disposal of asbestos-containing
products have been strictly regulated by
OSHA and the Environmental Protection
Agency. Do not use your cut-off machine
to cut or disturb asbestos, asbestos-
containing products, or products such as
pipes which are wrapped or covered
with asbestos insulation. If you have any
reason to believe that you might be
cutting asbestos, immediately contact
your employer or a local OSHA
representative.
10
WARNING
Your STIHL cut-off machine is designed
for hand-held use or operation on a cut-
off machine cart. Cutting with your cut-
off machine resting on the ground or
other surface can cause excessive wear
to the bracket designed to protect the
bottom of the tank housing. Loss of fuel
and personal injury from fire may result.
Replace damaged or badly worn
brackets immediately.
Grip: Never use the cut-off machine with
one hand. Always hold the cut-off
machine firmly with both hands when the
engine is running. Place your left hand
on front handle bar and your right hand
on rear handle and throttle trigger. Left-
handed users should follow this
instruction too.
Wrap your fingers tightly around the
handles, keeping the handles cradled
between your thumbs and forefingers.
Make sure your cut-off machine handles
and grip are in good condition and free
of moisture, pitch, oil, fuel mix or grease.
Never touch a rotating wheel with your
hand or any part of your body.
WARNING
Clear the area where you are working.
Avoid stumbling on obstacles and watch
out for holes or ditches. Be extremely
cautious when working on slopes or
uneven ground. Take extreme care in
wet and freezing weather (rain, snow,
ice.)
WARNING
Never operate the cut-off machine with
the starting-throttle lock engaged as this
does not permit proper control of the
speed of the unit and may lead to
serious injury.
WARNING
Sparks from cutting metal
can burn or cause cloth-
ing to catch fire. Always
direct sparks away from
the operator or any flam-
mable surroundings.
Never cut metal while
standing on a flammable
surface, such as wood or
tar paper. Where there is
a risk of fire, have appro-
priate fire extinguishing
equipment readily
available.
WARNING
To reduce the risk of injury from fire, do
not cut into any pipe, drum or other
container without first ensuring that it
does not contain a volatile or flammable
substance.
TS 700, TS 800