Publicidad
TEMPERATURE
INSIDE THE
CHAMBER
IS TOO HIGH
THE OVEN WILL
START
FORCED COOLING
PLEASE WAIT
WASHING WILL
START
AFTER COOLING
Fig. E
Fig. G. In all ovens of this series, the containers for the detergent and sparkling aid are located above the
oven.
ATTENTION! After a cooking process, the oven front panel and the top panel could be very hot.
It's necessary to be very careful to avoid any contact with very hot surfaces and we suggest you to use protec-
tion gloves.
Unscrew the cap of detergent container (this operation can be carried out simply by hands), introduce DETABI-
NOX
detergent tabs, following the instructions on the screen.
®
Screw the caps again and close the oven's door.
THE USE OF SPANNERS OR PLIERS TO SCREW AND UNSCREW THE CAPS IS FORBIDDEN.
TO HANDLE DETERGENT AND SPARKLING AID TABS, USE PROTECTION GLOVES AND MASK.
NOTE: to facilitate the dissolution of dirt, we advise to spray the internal part of the cooking cham-
ber with a degreasing product suitable for oven cleaning.
VERY IMPORTANT: to use BRILLINOX
gram.
6.0A AUTOMATIC WASHING SYSTEM WITH LIQUID DETERGENT
In models equipped with automatic washing with liquid detergent, in the back side of
the ovens supplied with automatic washing system, there are 2 small pipes for the
suction of detergent and sparkling-aid.
The red color pipe must be inserted into the liquid detergent container.
The white color pipe must be inserted into the liquid sparkling-aid container.
IMPORTANT NOTE: ensure that the liquid detergent and sparkling-aid are specific
for stainless steel cleaning.
Check frequently the level of the detergent and sparkling-aid inside their containers,
in order to avoid any damage to the pump if it works in vain.
Fig. E. If the chamber is too hot to start a washing cycle, the oven will show a message like the one shown on
the side.
The cooling cycle before the washing cycle can be effected both with open (in a shorter time) and with closed
door (in a longer time).
If you open the door to make cooling cycle quicker, wait for the following message (end of cooling) to close it
again.
Fig. F. Once the washing cycle has started, it's necessary to complete it, to avoid eventual detergent residuals
can contaminate the food during the following cooking processes or damage the stainless steel surfaces, when
in touch with too high temperatures.
If the oven is stopped during an automatic washing cycle, when you turn it on again the display will show a
warning message shown on the side, to remind you that you need to remove eventual detergent residuals and
effect a rinsing cycle before any cooking cycle.
THE OVEN HAS BEEN
IRREGULARLY
SWITCHED OFF
DURING A WASHING
CYCLE
REMOVE EVENTUAL
DETERGENT
RESIDUALS
FROM THEIR
RECEPTACLES
DO A RINSING CYCLE
Fig. F
sparkling aid, you need to select the RINSING pro-
®
17
Fig. G
EN
Publicidad
