Publicidad
Idiomas disponibles
Idiomas disponibles
mains socket;
• clean coated surfaces with soft cloth and
disinfect with alcohol;
• to clean internal parts of machine:
- turn the machine and lay it down on a
side;
- clean the internal parts with the help of a
soft cloth and blow with a compressed air
jet;
- disinfect with alcohol.
6.2 CLEANING OF THE ARCHIMEDEAN SCREW,
MIXER, RING NUT AND DRAWPLATE
Eliminate the dough residue and wash the
pieces with water; you may use a soft brush
or a plastic egg-slice.
These elements can be thoroughly washed
in a dishwasher. Rinse and dry the mixer, the
Archimedean screw and the ring nut and
reassemble them on the machine.
The drawplate (Fig. 15
container with water when it is not in use.
For reasons of hygiene, please change
the water every day.
7. MAINTENANCE AND ADJUSTMENT
WARNING: Remember that all main-
tenance operations are hazardous if
you do not first disconnect the power
supply plug from power mains.
The points of the machine which need a cer-
tain maintenance are the following: the tran-
smission gears, the dragging belt and the
mixer external support. Please carry out the
first maintenance after the first 100 hours
and thereafter every 500 hours.
Mixer support: Use registered fats for foods
(USDA-H1) (in case of requirement contact
your local dealer).
Transmission gears: please use mineral
grease SAE MR3.
All manuals and user guides at all-guides.com
(Fig. 15)
) is to stay in a
A
27
7.1 BELT STRETCHING
When performing the abovementioned
maintenance or when the machine is not
working properly, (loss of rounds) verify the
correct stretching of the transmission belt .
Never use the machine with any mis-
sing, disassembled or open guards
and shields.
If servicing operations require repairs
to electrical system and/or replace-
ment of bearings or mechanical com-
ponents, call an expert technician or
your local dealer.
8. MACHINE WHIRR
The whirring noise emitted by the machine
has been measured on an identical sample
machine in compliance with standard DIN
45635. A constant value not exceeding
70_dB(A) was measured as stated in the
manufacturer's test report.
9. DISMANTLING AND DEMOLISHING
THE MACHINE
If machine needs to be dismantled and/or
demolished, its components do not entail a
degree of danger that requires any particu-
lar precaution.
Remember, however, that to facilitate mate-
rial recycling operations, it is a good rule to
remove electrical system components from
the machine.
Publicidad
