Beem ESPRESSO-GRIND-EXPERT Manual De Instrucciones página 57

57
1. Take the porta昀椀lter (16) out of the device and empty it (see the "Preparation of the Device"
chapter – "Removing the Porta昀椀lter from the Device").
2. Remove the used sieve insert (17, 21) (see the "Preparation of the Device" chapter –
" Inserting / Removing the Sieve Insert").
3. Empty the drip tray (13) after each use (see the "Preparation of the Device" chapter –
"Inserting / Removing the Drip Tray").
4. Clean all used accessories with detergent and warm water.
5. Wipe the housing with a damp cloth. If necessary, use a little detergent to remove more
intense soiling.
6. Check the connecting cable regularly for any damage.
Cleaning the Steam Nozzle
To prevent any blockage, the steam nozzle (9) must be cleaned after each use.
1. Turn the steam nozzle over the drip tray (13).
2. Switch on the device by touching the 昀椀eld
The 昀椀eld 昀氀ashes slowly and the 昀椀elds
When preheating 昀椀nishes, all operating 昀椀elds and displays (apart from DESCALE (26) and
SINGLE / DOUBLE (28)) will be lit. The device is ready to operate.
3. Move the steam power control (8) to position
water and milk residues are rinsed out of the steam nozzle. The control lamp
4. Wipe down the steam nozzle with a damp cloth.
If the steam nozzle has become clogged, you can release the blockage with the cleaning
needle.
Cleaning the Grinder
1. Make sure that the device has been disconnected from the mains power.
2. Turn the bean container (1) anticlockwise until the scale mark on the device and the scale
arrow with the lock symbol on the bean container are aligned (Picture F).
3. Pull the bean container up and off.
4. Empty the bean container and carefully remove the rest of the beans from the grinder (3).
Make sure that the catch at the bottom of the bean container is fully closed (Picture G).
5. Place the bean container back on the grinder: The scale arrow with the lock symbol on the
bean container and the scale mark on the device must be aligned. Twist the bean container
clockwise until the grinding 昀椀neness scale is at the front.
6. Plug the mains plug into the plug socket.
(35). The device switches to preheating mode.
(33) light up.
(34) and
(Hot water). The device starts to emit
EN
(25) 昀氀ashes.