MACHEREY-NAGEL URYXXON Relax Manual De Instrucciones página 72

3.3 Note on ambient surrounding
If the device is exposed to higher temperature fluctuations (e.g. after transport or distribution),
it must be switched on not before sufficient acclimatization is given. The device should not
be used close to electrical fields (e.g. by microwaves, radio units et cetera). In worst case the
measurement results can be affected.
3.4 Setting up the instrument
Place the instrument on a hard, even surface where humidity and temperature are fairly
constant. Make sure that the instrument is allowed to acclimate to room temperature prior to
use.
Make sure that you
• Do not place the instrument near strong electromagnetic fields
• Do not place the instrument near heating plates, ovens or radiators
• Do not expose the instrument to strong light sources (i. e. direct sunlight)
3.5 Description of instrument parts


Pic 9: Front view
Actuator
1. Touch-Screen
2. Test Strip Slide
3. Printer Flap
4. Serial Interface
5. USB - Interface
6. USB - Interface
7. Mains Connection
8. On/Off Switch (I/O)
9. LAN-Interface
1
We recommend to use shielded cables.
2
We recommend to make use of the hand scanner from MACHEREY-NAGEL
Do only connect the intended devices to the corresponding interface. If you connect
another device to the corresponding interface, the analyzer or the connected device may
be damaged. Check all cables prior to use and verify the proper connection.
Manual URYXXON
72

Function
Control of equipment functions
Test strip retainer and autonomous start of analysis
Opening the printer flap for paper replacement
Connection of a computer (cable length
Connection of a computer (cable length
Connection of a keyboard or a bar code scanner
Contact for the provided power pack
Turning the equipment on and off
Connection to network (serial over LAN)
CAUTION
Relax EN, V 6.01 / 03.22
®

g
f e i
Pic 10: Backside view
1
max. 3 m)
1
max. 3 m)
2
d