Corghi ET 1450 Manual De Uso página 124

- use the
- press the
or LAS on to enable the laser device
or LAS oFF to disable the laser device
- press the
Caution
If the laser indicator is enabled, the application of the adhesive weights (except for
the ALU1 P and ALU2 P balancing programs with the weight-holder device present)
and the reference for selecting the two weights behind the spokes (Hidden Weight)
is at 6 o'clock (H.6).
CALIBRATION PROGRAM FOR
This operation must be performed when you feel that the machine is out of tolerance or
when it calls for self-calibration by displaying the message E 1 t on the display when it
is set up for truck wheels.
- Set the machine in truck balancing mode (LED next to TRUCK is lit).
- Mount an average size and balanced truck wheel (or one with fairly limited out-of-
balance)
- Input all the wheel data accurately
Proceed as follows to make these settings:
- press the
- use the
• press to launch the calibration procedure, which is carried out as follows:
- the machine shows the messages:
- CAL on the left display;
- GO on the right display.
- Perform a first spin.
. Once the spin stops (message "CAL StP" appears on display), rotate the wheel into the
position identified by the position indicator, when the message "200" (or "7", if ounces
display mode is selected) is displayed;
- Attach a 200 g (or 7 oz) sample weight to the INSIDE of the wheel rim, positioning at 12
124
keys to search for LAS on (LAS oFF if previously set)
key to change the setting:
key to confirm and exit.
TRUCK WHEELS
key;
keys to find the item Unb CAL
Operator's Manual ET 1450