Corghi ET 1450 Manual De Uso página 93

Internal weight
3
selection/
Decrease
4
Menu / Enter
Outer weight
5
selection/In-
crease
Wheel dimen-
6
sions
7
Stop
SWITCHING ON THE MACHINE
Connect the power supply cable (A, Fig.10) supplied
with the machine from the external electrical panel
located on the rear side of the wheel balancer body
to the mains.
Switch on the machine using the switch on the rear
side of the body (B, Fig.10).
The wheel balancer performs a checking test (all
the LEDs illuminate), and if no faults are detected,
a beeper sounds and the cycle status initially active
is displayed, as follows:
- active balancing mode: dynamic (dyn);
values displayed : --- ---;
- grams displayed in units of 5 (or 1/4 of an ounce);
- active sensor rounding-off
- preset geometric values for truck wheels (TRUCK environment):
Operator's Manual ET 1450
Multifunction key
1. in balancing mode, press this key to select the
type of weight to use on the inner side of the wheel.
2. in the menu press this key to navigate.
3. when entering dimensions manually, press this
key to decrease the displayed value.
Multifunction key
1. in balancing mode, press this key to access the
wheel balancer menu.
2. in a menu or in a program, press this key to
change the viewed option.
Multifunction key
1. in balancing mode, press this key to select the
type of weight to use on the outer side of the wheel.
2. in the menu press this key to navigate.
3. when entering dimensions manually, press this
key to increase the displayed value.
- Press this key to manually enter the wheel dimen-
sions in the case of an automatic measurement
system malfunction or for versions with a manual
internal sensor.
- Press this key to stop the spin
UK
10
93