Bostitch PS17-E Manual De Instrucciones De Funcionamiento Y Seguridad página 15

CODE POSSIBLE CAUSE
10 Hole in air hose
11 Check valve restricted
12 Air leaks
13 Regulator is damaged
Motor overload protection switch has
14
tripped
15 Extension cord is wrong length or gauge
16 Loose electrical connections
17 Possible defective motor
18 Paint spray on internal motor parts
19 Fuse blown, circuit breaker tripped
Tank pressure exceeds pressure switch
20
cut-in pressure
POSSIBLE SOLUTION
Replace air hose.
Remove, clean or replace.
Tighten fittings.
Replace.
See Motor Overload under 'Motor Overload Protector'.
Check for proper gauge wire and cord length. See table under
'Extension Cords'.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center. Do not operate the compressor in the
paint spray area. See flammable vapor warning.
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper extension
cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Motor will start automatically when tank pressure drops below
cut-in pressure of pressure switch.
ENGLIS H
15