How To Use The Operation Panel; Basic Operation Of The Sewing Machine; Setting The Thread Tension - JUKI MEB-3200 Manual De Instrucciones

6. HOW TO USE THE OPERATION PANEL

1. For J and C type, the pattern No. which is different in the presser type cannot be used.
The standard patterns which can be used with the respective presser types are as shown below.
(See page 70 for the standard
patterns.).
2. For T type, No. 90 to 96 for S and
M types can be used.

(1) Basic operation of the sewing machine

(2) Setting the thread tension

The actual thread tension varies in accordance with the kind or thickness of thread used even when the
set value is the same. Adjust the thread tension value to the thread used. If the thread tension set value
is high, stitch skipping may be caused.
■ Setting of the looper thread tension
1) Press [LOOPER
thread tension value.
2) Press [RIGHT ] key
When pressing [RIGHT
When pressing [RIGHT
3) Press [READY
When the pattern No. is changed without performing the operation of step 3) or turning OFF the
power, the set value is not stored in memory.
16
] key to display the looper
or [RIGHT ] key
] key to increase the numeric, the thread tension is increased.
] key to decrease the numeric, the thread tension is decreased.
] key or when starting sewing with the start switch, the set value is stored in memory.
S type
C type at the time of delivery
M type J type at the time of delivery
L type
1) Set the display to pattern No. with [PATTERN
key .
2) Press [LEFT
select the pattern desired to be sewn.
3) Press [READY
and to make it possible to sew. At this time,
feed base, knife and needle bar perform the origin
retrieval.
4) Set the sewing material to the presser section, and
lower the presser using the presser switch. Press the
start switch and the sewing machine starts sewing.
■ Setting of the needle thread tension
1) Press [NEEDLE
thread tension value.
2) Press [RIGHT
change the set value.
When pressing [RIGHT
the numeric, the needle thread tension is
increased.
When pressing [RIGHT
the numeric, the needle thread tension is
decreased.
3) Press [READY
with the start switch, the set value is stored in memory.
When the pattern No. is changed without
performing the operation of step 3) or turning OFF
the power, the set value is not stored in memory.
to change the set value.
No.90, No.91, No.92
No.93, No.94, No.95, No.96
No.97, No.98, No.99
] key or [LEFT ] key
] key to light up sewing LED
] key to display the needle
] key or [RIGHT ] key
] key to increase
] key to decrease
] key or when starting sewing
]
to
to