Compensation Of Turning; Parallel Section Turning Compensation; Eyelet Crosswise Compensation; Eyelet Lengthwise Compensation - JUKI MEB-3200 Manual De Instrucciones

(3) Compensation of turning

(4) Parallel section turning compensation

Setting range is − 14 ≦ compensation of turning ＋ compensation of turning at parallel section ≦ 14.

(5) Eyelet crosswise compensation

(6) Eyelet lengthwise compensation

(7) Left eyelet lengthwise compensation

34
＋
Set the turning angle with [RIGHT
[RIGHT
−
Setting can be performed − 14˚ to 14˚.
Set the turning angle with [RIGHT
＋
[RIGHT
W h e n t h e t u r n i n g c o m p e n s a t i o n o f t h e
−
a f o r e m e n t i o n e d ( 3 ) i s p e r f o r m e d , t h e
compensation is performed in the form of adding
the compensation value of turning of (3).
− ＋
Set the position with [RIGHT
Setting can be performed − 0.6 to 0.6 mm in the
increments of 0.1 mm.
＋
− Set the position with [RIGHT
Setting can be performed − 0.2 to 0.6 mm in the
increments of 0.1 mm.
−
Set the length with [RIGHT
＋
Setting can be performed − 0.2 to 0.6 mm in the
increments of 0.1 mm.
Turning angle of the eyelet section and of
the parallel section can be adjusted.
] key .
Turning angle of parallel section and
bottom of eyelet can be adjusted.
] key .
Position on the top of eyelet can be
moved to the right- or left-hand.
] key .
Shape on the top of eyelet can be expanded
or contracted in the longitudinal direction.
] key .
Length of the left side on the top of eyelet
can be adjusted.
] key .
] key or
] key or
] key or [RIGHT
] key or [RIGHT
] key or [RIGHT