Compensation Of The Data; Knife Position Compensation; Number Of Stitches Of Sewing End Compensation - JUKI MEB-3200 Manual De Instrucciones

9. COMPENSATION OF THE DATA

The data No. is stated in 2-digit LED
shown below. The setting range is stated in the respective sentences.
S t i t c h e s o f t h e r e s p e c t i v e
compensations as shown below
are expreseed by the stitches as
observed from the right side of
stitching.

(1) Knife position compensation

(2) Number of stitches of sewing end compensation

1) Confirm that sewing LED
When the LED lights up, press [READY
to make it go out.
2) Display the pattern No. desired to be changed.
3) Press [DATA
4) Press [LEFT
display the data No. of the part desired to be
changed.
5) Press [RIGHT
re-set the respective data.
6) Press [READY
and the data are stored in memory.
When changing the pattern No. without
pressing [READY
the power, the data are not stored in memory.
It is necessary to set again the data.
7) When the memory switch No. 20 is equal to
"1", change of setting the data in step 5) can be
prohibited.
and the example of the set value is stated in 4-digit LED
Wrong side
of stitching
＋
1) When the knife position in terms of the stitches
−
is desired to be placed in the rear side, set " ＋ "
(plus) value, and in the front side, set " − "
(minus) value.
2) Set the knife position with [RIGHT
[RIGHT
0.7 to 0.7 mm in the increments of 0.1 mm.
Set the number of stitches with [RIGHT
or [RIGHT
Setting can be performed as follows :
−
＋
has gone out.
] key to display the data.
] key or [LEFT
] key or [RIGHT
] key to light up sewing LED
] key
Right side
of stitching
Correct the slip between the position of
knife and sewing position.
] key . Setting can be performed −
Number of stitches of sewing end can be
increased at the same sewing pitch.
] key .
Without bartack ... − 1 to 6 stitches
Taper bar ... − 1 to 6 stitches
Straight bar ... − 1 to 3 stitches
] key
] key to
] key and
or turning OFF
as
] key or
] key
33