Position Of The Presser Foot And The Needle Entry Point; Adjusting The Knife Dropping Position - JUKI MEB-3200 Manual De Instrucciones

(6) Position of the presser foot and the needle entry point

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
A
0 to 0.5 mm

(7) Adjusting the knife dropping position

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
50
B
Adjust the clearance between the presser
foot and the holding plate to 0 to 0.5 mm.
Loosen two setscrews
and the adjust the clearance. Then fix the presser
arm in place.
Moving presser arm
reduce the clearance between the presser
foot and the outside needle entry point.
＊ The front or rear inclination can be adjusted with
presser arm setscrew
Upper knife type
●
Loosen setscrew
installing base, adjust cloth cutting knife installing
base to the left or right. Then fix the base.
Lower knife type
●
Loosen setscrews
knife base to the left or right. Then fix the knife
base.
in the presser arm base
in the direction A will
.
in the cloth cutting knife
in the knife base and adjust