When Dropping Of The Knife Is Temporarily Not Desired; Changing The Operation Mode - JUKI MEB-3200 Manual De Instrucciones

(7) When dropping of the knife is temporarily not desired

(8) Changing the operation mode

5) Press the start switch. When the cut-before knife is used, and the position of the feed base is not in the
position of the knife, the feed base moves to that of the knife.
6) Press the start switch. When the cut-before knife is used, the cloth cutting knife works.
7) Press the start switch. The cloth open mechanism is opened.
8) Press the start switch. The feed base travels to the sewing start position and the buzzer beeps.
9) Turn the handwheel in the direction of the arrow mark. The feed base interlocking with the needle
position travels stitch by stitch.
Turn the handwheel and when the feed base comes to the sewing end position, the buzzer beeps.
10) It is possible to make the feed base only travel up to the sewing end position using [FORWARD
or [BACK ] key
11) Every time the start switch is pressed, the feed base travels and needle thread trimming operation or
looper thread trimming operation is performed step by step. When the after-cut knife is used, the cloth
cutting knife operation is performed step by step.
12) When temporarily stopping the change, press [RESET
position.
Be sure to turn the handwheel in the normal direction since the feed mechanism does not perform
the receding operation even when the handwheel is turned in the reverse direction.
.
1) Press [KNIFE ] key
The knife does not work when the LED goes out.
2) Press [KNIFE ] key
light up and the knife can be operated.
• When sewing LED
[ A U T O ] k e y
operation mode.
• The machine works in [MANUAL mode]
when the AUTO LED
[AUTO mode] when the AUTO LED lights up.
[AUTO mode]
Lower the presser foot, press the start switch, and a
sequence of operation such as drive of cloth cutting
knife, sewing, thread trimming, etc. is performed.
This is the normal sewing mode.
[MANUAL mode]
This operation mode is an operating procedure to
turn the handwheel by hand without rotating the
sewing machine so that a step operation which
makes the feed base travel stitch by stitch is
performed. In addition, the knife operation, and
the thread trimming operation can be performed
step by step.
1) Make sure that sewing LED
When it lights up, press [READY
make it go out.
2) Press [AUTO ] key
3) Press [READY ] key
and to make the sewing possible.
4) Lower the presser with the presser switch.
] key and the feed base returns to the set
to make the LED go out.
again to make the LED
goes out, press
t o c h a n g e t h e
goes out, and in
has gone out.
] key to
to make AUTO LED go out.
to light up sewing LED
] key
19