Husqvarna FS 4600 G Manual De Usuario página 13

• Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
• Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
WARNING:
rearward and cause injury or damage. Be
careful when you tilt the product rearward or
lift the product.
WARNING:
operate the product on rough level surface
or on slopes. The product can easily tilt
rearward or start to move and cause injury
or damage. Stay behind the product until the
product is on a level surface.
WARNING:
down a ramp in freewheel position. Always
move the product forward down ramps and
slopes. Do not walk beside or stay below the
ramp when you move the product down a
ramp.
• Read this operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Read the instructions that are supplied with the
cutting blade by the cutting blade manufacturer.
• Before you start the product for the first time, do
these steps:
a) Install a new battery and connect the battery
cables. Refer to
battery on page 42 .
Note:
For some markets, the battery is
installed when you purchase the product.
b) Set the correct language and do other necessary
settings on the display. Refer to
settings in the submenus on page 25 .
• Before each operation of the product, do these
steps:
1657 - 004 - 07.03.2022
Read and understand the
The product can easily tilt
Be careful when you
Do not move the product
To connect and disconnect the
To change
• Let an approved service center do servicing on the
product regularly.
Operation
a) Do the daily maintenance. Refer to
schedule on page 27 .
b) Make line marks for all cuts. Prepare the
operation sequence carefully to prevent injury
and damage.
c) Adjust the operation handles to an applicable
operation position. Refer to
of the operation handles on page 14 .
d) Lower the adjustable pointer and make sure that
it aligns with the rear pointer, the cutting blade
and the line mark on the surface. Refer to
do a check of the pointers on page 13 if the
pointers and the cutting blade do not align.
e) If it is necessary, adjust the length of the
adjustable pointer with the screw (A) on the
adjustable pointer. Adjust the width of the
adjustable pointer with the screw (B).
To do a check of the pointers
1. Put a long straight metal bar or equivalent against
the cutting blade.
2. Make sure that the rear pointer, the cutting blade
and the adjustable pointer align.
a) Adjust the adjustable pointer with the screws.
Refer to
on page 13 .
b) To adjust the rear pointer, loosen the screw on
the rear pointer.
To adjust the position
B
To do before you operate the product
Maintenance
To
A
13