Husqvarna FS 4600 G Manual De Usuario página 43

1. Connect one end of the red battery cable to the
POSITIVE (+) battery terminal (A) on the weak
battery.
B
A
2. Connect the other end of the red battery cable to the
POSITIVE (+) battery terminal (B) on the charged
battery.
WARNING:
the red battery cable touch the chassis.
This will cause a short circuit.
Troubleshooting
WARNING:
blade stops, lift the cutting blade fully from
Problem Cause
The engine The fuel tank is empty.
stops during
The machine stop button is pushed down.
operation.
Too high load on the cutting blade.
A fuse is broken.
The cutting The tension of the drive belts are not sufficient.
blade stops
during opera-
tion.
The cutting The cutting blade is blunt or the feeding pres-
blade cuts too sure is too high.
slowly.
Incorrect gear is selected.
1657 - 004 - 07.03.2022
C
D
Do not let the ends of
Troubleshooting
If the engine or cutting
3. Connect one end of the black battery cable to the
NEGATIVE (-) battery terminal (C) on the charged
battery.
4. Connect the other end of the black battery cable to
a CHASSIS GROUND (D), away from the fuel tank
and the battery.
5. Start the product and then remove the jumper
To remove the jumper cables on
cables. Refer to
page 43 .
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
the cut. Set the ignition key to the "0"
position and push the machine stop button.
Examine the product fully before you start
the product again.
Solution
Fill the fuel tank with correct fuel type.
Pull up the machine stop button to reset the ma-
chine stop.
Listen to the sound of the engine. If the engine
speed decreases, pull the lever for speed control
rearward.
Replace broken fuses.
Examine the tension of the drive belts.
Decrease the cutting depth and engine speed
for a short time.
Make sure that the correct gear is selected.
Move the gearshift lever to the applicable gear.
43