Husqvarna FS 4600 G Manual De Usuario página 42

3. Lubricate (A) the 2 male motor connectors.
A
4. Connect the 2 motor connectors.
5. Put the 2 motor connectors back into the product.
For more information about lubrication, refer to
Technical data on page 48 .
Battery maintenance
Note:
The battery on your product is maintenance
free. Do not open or remove the caps or the covers.
To connect and disconnect the battery
1. Install the battery holder (A).
2. Connect the red battery cable to the POSITIVE (+)
battery terminal on the battery.
3. Connect the black battery cable to the NEGATIVE (-)
battery terminal on the battery.
4. Disconnect the battery cables in the opposite
sequence of how they were connected.
WARNING:
NEGATIVE (-) battery terminal first.
5. Remove the battery holder.
42
A
Always disconnect the
To do a check of the battery
• Do a check of the battery daily.
a) Turn the ignition key to the "I" position.
b) Examine the battery gauge in the display. It must
not be below 12V.
94°F
13.8
• If the battery gauge is below 12V, charge or replace
the battery.
• Replace the battery if it cannot keep the voltage.
This can occur if the product is not operated for
a long time. For information about recommended
Technical data on page 48 .
batteries, refer to
• Charge the battery regularly.
• Keep the battery terminals and the battery cables
clean.
To do an emergency start of the engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground and minimum 700 CCA.
To connect the jumper cables
WARNING:
of explosive gas that comes from the
battery. Do not connect the negative
terminal of the charged battery to or near the
negative terminal of the weak battery.
CAUTION:
your product to start other vehicles.
1000 25°F
89.0 123
Risk of explosion because
Do not use the battery of
1657 - 004 - 07.03.2022