Husqvarna FS 4600 G Manual De Usuario página 33

To do a check of the water supply to
the cutting blade
1. Loosen the front bolt (A) on the blade guard and lift
the blade guard latch.
A
2. Lift the blade guard front (B) to the upright position.
3. Lock the blade guard in upright position with the wire
and the carabiner.
4. Open the water valve.
1657 - 004 - 07.03.2022
5. Make sure that the jets of water go straight out from
the holes and onto each side of the cutting blade.
B
6. Make sure that there are no leakages in the water
hoses.
7. Replace the water hoses if they are damaged.
To replace the engine oil and engine oil
filter
1. Remove the cap (A) from the oil drain hose for
engine oil.
A
2. Open the valve and bend the hose down to drain the
engine oil.
3. Remove the engine oil filter (B) and discard it.
4. Close the valve.
5. Lubricate the seal with some drops of engine oil.
6. Install the engine oil filter on the product.
B
33