Husqvarna FS 4600 G Manual De Usuario página 17

19. Unlock the blade guard from the carabiner and lower
the blade guard front (I). Put the blade guard latch
on the front bolt of the blade guard (J). Tighten the
front bolt of the blade guard.
J
CAUTION:
product without the blade guard latch
engaged. Do not use the product if the
parts are damaged.
20. Push the lever for cutting depth adjustment rearward
until the cutting blade is above the surface.
21. Start the product. Refer to
page 19 .
22. Listen for unusual sounds. If there are unusual
sounds, remove the cutting blade
a) Examine the cutting blade for damages.
b) Install the cutting blade again. Replace the
cutting blade if it is damaged.
To remove the cutting blade
WARNING:
diamond blades, let the product become
cool and use protective gloves. Diamond
blades are very hot after use.
1657 - 004 - 07.03.2022
I
Do not operate the
To start the product on
When you remove
• Remove the cutting blade in the opposite sequence
of how it was installed. Refer to
blade on page 15 .
To install a blade guard
1. Install the blade guard onto the support (A).
2. Connect the water hose.
To remove the blade guard
• Remove the blade guard in the opposite sequence of
how it was installed. Refer to
on page 17 .
3-speed gearbox
The product has a 3-speed gearbox. The gearbox has
3 speed positions, "L(1)", "H(3)" and "M(2)". 3 different
cutting blade dimensions can be used on the product.
The gear must be changed if the dimension of the
cutting blade is changed. Refer to the table below.
To install a cutting
A
To install a blade guard
17