Publicidad
Idiomas disponibles
Idiomas disponibles
5. Push or tap up the throttle control switch to increase
the engine speed to full throttle.
6. Keep the adjustable pointer, the rear pointer and
the cutting blade on the line mark during the full
operation.
7. Push the lever for cutting depth adjustment forward
to lower the cutting blade to the correct cutting
Blade depth stop on page 18 .
depth. Refer to
CAUTION:
blade into a cut that is not fully
completed, align the cutting blade
accurately with the cut to prevent
damage to the cutting blade.
8. Push the lever for speed control forward slowly to
move the product forward.
9. Listen to the sound of the engine. Pull the lever for
speed control rearward to adapt the forward speed
to the sawing conditions.
22
If you lower the cutting
10. When the operation is completed, set the lever for
speed control in the stop position.
11. Push the lever for cutting depth adjustment rearward
until the cutting blade is above the surface.
12. Push down and hold the throttle control switch until
the engine operate at idle speed.
To operate the differential locking function
Differential locking of the rear axle is used for good
traction on slippery surfaces. The differential locking
function gives power to both wheels but disables the
pivoting function, which limits the maneuverability.
1657 - 004 - 07.03.2022
Publicidad
