Beurer BF 1000 Super Precision Instrucciones De Uso página 34

12. ADDITIONAL INFORMATION
Deleting scale data
a) Delete user with all settings and saved values
• After switching on, select your user by pressing the [
several times and confirm with [SET].
• When 0.0 appears in the display, hold down the [SET] button for 12 seconds to delete the user.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do
not want to delete the user, confirm "NO" using the [SET] button.
All saved values and settings for this user will be deleted.
b) Delete individual saved value for a user
• Select a measured value in the user memory
unit to delete the stored value displayed.
• You can also do this immediately after the measurement is taken.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do
not want to delete the value, confirm "NO" using the [SET] button.
c) Delete all stored values for a user
• Open the user memory
delete all values.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do
not want to delete, confirm "NO" using the [SET] button.
Changing the batteries
The control unit has a low battery indicator. "LOW BATTERY" appears in the display if the batteries in
the scale are too weak. In this case, the batteries should be replaced. Connect the scale to the app
again. The system time is updated.
Note:
• When replacing the batteries, use batteries of the same type, make and capacity.
• Do not use rechargeable batteries.
• Use batteries free from heavy metals.
13. CLEANING AND MAINTENANCE
Clean the surface of the scale from time to time using a slightly damp cloth. Do not use the scale again
until the surface is completely dry.
IMPORTANT
• Do not use any abrasive cleaning products.
• Never submerge the scale in water. Never rinse the scale under running water.
• Do not place any objects on the scale when it is not in use.
• Protect the scale from knocks, moisture, dust, chemicals, drastic changes in temperature and
nearby sources of heat (ovens, heaters).
and press the [SET] button on the control unit for around 5 seconds to
34
] button. If necessary, press the button
and briefly press the [SET] button on the control