Publicidad
Idiomas disponibles
Idiomas disponibles
9.1 START
The Rotary blades vacuum pump does not have a start button. Therefore to start it just transmit the motion to the power take-off
(P.T.O.). The way this is done depends on the version of Rotary blades vacuum pump. Before starting make sure that the rotary
blades vacuum pump is supplied with oil for internal lubrication (and lubrication of gearbox in versions .../M-MA and .../K-KA).
Before starting the rotary blades vacuum pump, make sure that the guards on all the moving parts are in place
and efficient. Any damaged or missing components must be replaced and installed correctly before using the
transmission.
For .../M-MA, K-KA, D version clean and grease the power take off before to install the cardan transmission.
9.2 OPERATION
Do not use the Rotary blades vacuum pump at pressures, temperatures, times higher than those indicated in Table
6. During use do not exceed the speed and power limits set in this manual. Do not overload the machine or suddenly
engage the P.T.O.
Check the following operating parameters.
Revs MEC STAR M, K. HM
Revs MEC STAR MA, KA
Revs MEC P, D, H,
Revs STAR P, D, H,
Pressure
Vacuum
Outside temperature side cylinder compression
Working time with standard blades -0,80 bar
Working time with long life blades -0,80 bar
Table 5
We recommend the use of the rotary vane vacuum pump reducing the maximum pump revolutions shown on
the plate by 10%, to reduce oil consumption, blade wearing and noise. For special or heavy use, it is advisable to
contact the technical office
Failure to comply with the instructions given in this manual may be dangerous for the user health or may damage
the rotary blades vacuum pump. If density of material to suck is high, dilute or mix the material same.
The working time should be such that the maximum temperature is never reached. Prolonged operation without
interruption may cause damage to the blades as well as overheating.
9 - START , OPERATION, STOP
PARAMETER
for use and maintenance serie MEC, STAR
MAXIMUM RATE
[rpm]
[rpm]
[rpm]
[rpm]
[bar]
[bar]
[°C]
[min]
[min]
instruction manual
600
1000
1400
1200
1,5
-0,95
130
6-8
15
pag. 51
Publicidad
