Sirona ORTHOPHOS XG 3Dready Manual De Instrucciones página 92

7 Updating the unit software and configuring the unit
Perform a software update
Confirming the unit class
38
Converting Instructions "ORTHOPHOS XG 3D
7
Updating the unit software and configuring
the unit
Updating the unit software and configuring the unit
IMPORTANT: The current update file can be found on the ORTHOPHOS
XG3D Firmware CD. This is included in the XG 3D conversion set (IT
package) and also the country-specific set. The contents of the CD can
be downloaded from the Dealer domain of the Sirona Internet home page
(under Product Info/X-ray Systems): www.sirona.com
Update: XG Ready to XG 3D
✔
The IT package from the XG3D upgrade kit must be installed.
✔
The unit is mechanically converted to ORTHOPHOS XG 3D.
"Automatic"
1. In
to the latest unit software version, as described in the ORTHOPHOS
XG5/XG
NOTICE! At this point, do not acknowledge any error messages on
the unit or the PC (e.g. "Timeout suspected").
2. Switch the unit off.
Wait approx. 1 minute. Then switch the unit on again.
Error message E6 11 07 (undefined system class) is displayed.
1. Acknowledge the error message with the R key .
The access level for the service menu (level 4) is automatically
started.
2. Press and hold down the service key (D) until the patient symbol keys
light up (approx. 2 s).
3. Then press the patient symbol keys in the sequence F – H – E within
the next 4 s.
ready
to ORTHOPHOS XG 3D" ORTHOPHOS XG 3D
update mode, perform an automatic software update
Plus ready
and XG 3D Service Manual.
Sirona Dental Systems GmbH
ready
63 14 541 D3352
D3352.092.08.05.02 079.2012