GE Profile P9SBAAS6VBB Manual Del Usuario página 29

Care & Cleaning
Smoke Chamber Light
WARNING
SHOCK OR BURN HAZARD:
electrical power to the oven at the main fuse or circuit breaker panel. Failure to do so may result in
electric shock or burn.
WARNING
BURN HAZARD:
hot glass with bare hands or a damp cloth can cause burns.
Before replacing the bulb, disconnect electrical power to the smoker by unplugging the power cord.
Make sure the glass cover and bulb are cool before attempting to remove them. For your safety, do not
touch a hot bulb with a damp cloth, as the bulb may break.
To remove the glass cover, pull down on the edges of the glass cover. A flat-blade screwdriver may be
used to carefully pry the cover open. Support the light cover to prevent the cover from falling to the
bottom of the smoke chamber. Take care not to break the glass cover or chip the enamel coating on the
smoking chamber.
Once the glass light cover is removed, remove the bulb by firmly grasping and slide the bulb straight out
until the two prongs have cleared the socket.
Do not touch the glass of the new replacement bulb with your fingers. This may cause the bulb to fail
prematurely. Grasp the replacement bulb with a clean towel or facial tissue with the prongs facing down.
Align the two prongs with the socket and gently slide the prongs into the socket. Push firmly to ensure
the bulb is fully seated.
Reinstall the glass light cover before reconnecting power to the smoker.
NOTE: Only replace the smoke chamber light with a 25-watt G9 halogen bulb.
49-9000057 Rev. 1
Before replacing oven light bulb, disconnect the
The glass cover and bulb should be removed when cool. Touching
29