HOLZMANN MASCHINEN D460FXL 230 V Manual De Instrucciones página 41

Machine overruns!
After switching off, stay with the machine until the workpiece comes to a

standstill. Never stop the rotation by hand!
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before cleaning,
maintenance or repair work and secure it against unintentional reconnection.
16.1 Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its
safe operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
• Remove chips and dirt particles from the machine after each use with compressed air and
a soft brush.
• Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
16.2 Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or
defects that could affect your safety must be repaired immediately!
• Before each operation, check the perfect condition of the safety devices.
• Regularly check the perfect and legible condition of the warning and safety labels of the
machine.
• Use only original spare parts recommended by the manufacturer.
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions.
The following intervals apply when the machine is used within the technical limits:
Interval Component
• guide paths
• centre punch tip and spur
before starting
work
• motor
• cable connection
HOLZMANN MASCHINEN GmbH
C AU TI O N
WAR N I N G
center
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O TE
Activity
• oil
• Keep the tool, especially the thread
cone, free of dust and apply a thin layer
of oil.
• Check that the ventilation slots are free
of contamination.
• Check, replace if damaged.
41
D460FXL_230V