NOTE!
The welding parameters are specified using analogue set values.
Signal level when bit 0 - bit 2 are set:
Signal level in standard mode
Stecker X1/7 (Bit 0) = High
Stecker X1/8 (Bit 1) = High
Stecker X1/9 (Bit 2) = High
Job number (Job
-
number)
-
Connector
X1/10
X1/11
X1/12
The desired job number must be selected using bit coding (0-7 possible job num-
bers):
-
-
-
-
-
NOTE!
Job number "0" allows a job to be selected on the power source control panel.
The Job number signal is available if the special 2-step mode or Job mode
characteristic was selected using Working mode bits 0 - 2.
-
For more information on Working mode bits 0 - 2, see
(Working mode)
from page 26.
Saved welding parameters are called up using the number of the correspon-
ding job by the Job number signal.
00000001 = job number 1
00000010 = job number 2
00000011 = job number 3
etc.
00000111 = job number 7
Signal level in OC mode
Stecker X1/7 (Bit 0) = Low
Stecker X1/8 (Bit 1) = Low
Stecker X1/9 (Bit 2) = Low
Working mode
Standard mode
OC mode
24 V - bit 1
0 V - bit 1
24 V - bit 2
0 V - bit 2
24 V - bit 3
0 V - bit 3
27