cecotec BOLERO DRESSCODE 8800 INVERTER A Manual De Instrucciones página 108

ENGLISH
Steam washing
Press the STEAM button to add a steam wash process after the last water drain stage of the
selected (or ongoing) wash cycle and before the last spin. In the steam washing process, the
machine generates a large amount of high temperature steam that penetrates deep into the
fabric, improving the softness and elasticity of the laundry and, at the same time, eliminates
odour and refreshes the laundry. After the steam washing process, the machine enters the
final stage of draining and spinning.
Child Lock
1. The setting of the child lock function can prevent malfunctions or unwanted incidents.
2. During operation, press and hold the SPEED button for approximately 3 seconds to set or
cancel the child lock function.
3. After setting the child lock function, its indicator light comes on, the door cannot be opened
and the control panel is locked, the buttons remain inactive, as well as the wash cycle selector
(the indicator light below the power symbol is on ). The machine can only be switched off
by turning the wash cycle selector to its OFF position, the indicator light below the power
symbol will go out and the device will stop operating. If the machine is switched off, the child
lock function will be cancelled.
4. After setting the child lock function, you can switch off the machine by turning the washing
cycle knob. When the machine is switched on again, it will directly run the selected programme
before it was switched off.
Adding laundry during a washing cycle
When the programme is running, press and hold the START/PAUSE button to pause the
machine. If the DOOR LOCK indicator light goes out, the door can be opened, you can add or
remove laundry. Once the operation is complete, close the door, press, and hold the START/
PAUSE button again and the machine continues to run from the point where it was interrupted.
NOTE:
If the water level or water temperature in the drum is too high, the door lock indicator light
comes on, the door cannot be opened, and laundry cannot be added or removed during the
programme run (for safety reasons).
Load Balancing System
The washing machine has an automatic eccentric load detection system. In the spinning
process, if the laundry is unevenly distributed, the appliance will level and adjust the laundry
until it is evenly distributed before spinning. If the laundry cannot be evenly distributed within
the specified time, the appliance will not rotate to avoid excessive vibrations. At this point, you
should check whether the laundry is knotted or tangled and select the SPIN programme after
rearranging the laundry. When you wash less laundry, such as a pair of trousers, a jumper, a
bath towel, etc., the machine may not complete the spinning process due to balance protection.
108
BOLERO DRESSCODE 8800 INVERTER A / INVERTER STEEL A / INVERTER ICE BLUE A