cecotec BOLERO DRESSCODE 8800 INVERTER A Manual De Instrucciones página 116

ENGLISH
Water spillage from
detergent dispenser
Water leaks
Does not turn on
Wash cycle does not start
No water or detergent
enters the drum. Error
"E02" appears on the
screen
Water discharge when the
programme starts
116
BOLERO DRESSCODE 8800 INVERTER A / INVERTER STEEL A / INVERTER ICE BLUE A
The dispenser is blocked with detergent and requires
cleaning.
The water pressure is too high and needs to be lowered; close
the tap on the water supply pipe slightly and try again.
The appliance is tilted forward - It must be level when in its
final position.
Water supply hose is loose, check connections.
Water supply hose is tight but still leaks; if so, replace the
rubber washers, or the water supply hose does not have the
rubber washer.
The drain hose is not positioned correctly.
In case of water leakage inside the machine, turn off the
power supply and contact Cecotec Technical Support.
Appliance is not fully plugged in or not plugged in enough to
make contact.
No power is reaching the socket. Check the fuses and control
and protection elements of the electrical installation.
The door is not closed properly.
The "START/PAUSE" button has not been pressed.
The water tap has not been turned on to allow water to flow
into the appliance.
A delayed end function has been configured.
Water supply hose is kinked or bent.
The water supply hose is not connected to the water supply.
The water pressure is too low.
The water tap has not been opened to allow water to flow
into the machine.
There is no water supply in the dwelling.
The mesh filter in the water supply hose and/or the water
inlet valve is/are blocked.
Tap and/or water supply pipe is/are frozen.
The START/PAUSE button has not been pressed.
There is already enough water in the drum.
This is not an issue. Do not open the door to pour water
directly into the drum before the programme is run,
otherwise the machine may discharge the water that was
poured into the drum when the programme was started.