cecotec BOLERO DRESSCODE 8800 INVERTER A Manual De Instrucciones página 112

ENGLISH
- The remaining duration of the programme may vary. Factors such as imbalance in the
wash load or foam formation may affect the programme duration.
8. Change the configuration of a running programme, if necessary
- You can change the settings while a programme is running. The changes shall be
implemented as long as the respective programme phase has not been completed yet.
- To change the configuration of a running programme:
- Press the "START/PAUSE" button to pause the running programme.
- Change your settings.
- Press the START/PAUSE" button again to continue the programme.
- If you have changed the programme, do not add detergent for the new programme.
- To prevent a running program from being accidentally changed (e.g., by children), use the
Child Lock function.
Pausing a running programme and opening the door
- Press the START/PAUSE
- If the water level and/or temperature in the drum is/are not high, the DOOR LOCK indicator
light will go out. You can open the door, for example, to add more laundry or to remove laundry
that was loaded by mistake. Press the START/PAUSE button again to continue the programme.
9. Cancellation of a running programme (if necessary)
- Turn the wash cycle selector to turn off the machine while the light under the "
is on.
- If the water level and/or temperature is low enough, the door will unlock and can be
opened.
- The door will remain locked if there is a higher water level in the drum. To unlock the door,
first turn the wash cycle selector to select the SPIN programme, then turn off the SPIN option
by pressing the SPEED button to set the spin speed to "-" (should be displayed on the digital
display).
- Press the START/PAUSE button to run the SPIN programme. Water will drain from the drum
during the wash cycle. The door unlocks at the end of the programme.
10. Switching off the device after the end of a washing programme
- At the end of the cycle, the message "END" is shown on the digital display.
- The door can only be opened when the DOOR LOCK
- Check that the DOOR LOCK indicator light is off, then open the door and remove the laundry.
- Turn the wash cycle selector to switch off the machine to the OFF position.
- Leave the door ajar to allow the inside of the drum to dry out and prevent odours and
mould growth.
112
BOLERO DRESSCODE 8800 INVERTER A / INVERTER STEEL A / INVERTER ICE BLUE A
button to pause the running programme.
indicator light goes out.
" symbol