cecotec BOLERO DRESSCODE 8800 INVERTER A Manual De Instrucciones página 115

To access the drain pump filter, you must first open the cover on the bottom right-hand side.
Press lightly to open the lid (Fig. 23). With the lid open, proceed as follows:
1. If the appliance has not been drained, try draining it now. First, turn the wash cycle selector
to select the "SPIN" programme, press the "SPEED" button until the display shows "-", then
press the "START/PAUSE" button. Wait a moment for the pump to drain the water from the
drum. If the pump is totally blocked, the water will not be able to drain, and the cycle will end.
2. Turn off the tap so that no more water enters. Switch off the appliance. Disconnect the
power cord from the plug.
3. Use the removable drain hose located on the filter access opening to drain the remaining
water into a suitable container (up to 20 litres of water can be drained). Remove the plug from
the hose and place it over the side of a suitable container and allow the water to drain out of
the drum. When finished, replace the sealing plug on the end of the hose and return the hose to
its storage location. Be careful not to spill the drained water on the floor (Fig. 24).
4. Turn the filter cover counterclockwise to remove the filter. A small amount of residual water
may flow out when the lid is removed. Clean the inside, as well as the filter itself, removing any
debris or foreign objects. Remove any lint, dirt or detergent residue from the filter thread. You
can use water, a cloth or a soft brush. Reinstall it in its original position (Fig. 25).
5. Close the lid and wipe up any water spillage (Fig. 26).
6. TROUBLESHOOTING
Problem
There are coloured stains
and oil stains on the drum
Bad smells
The door cannot be
opened
Cause and possible solution
The appliance requires a service wash. Run a DRUM CLEAN
wash cycle without detergent and laundry.
Due to the use of rubber parts, the machine will have a
rubber smell at the beginning of use, but the rubber smell will
gradually disappear during use.
Leave the door ajar after each wash cycle.
The safety protection function is in operation and the water
temperature and/or water level are too high.
If the programme has finished normally, but there is a power
failure.
Is the CHILD LOCK function activated? Deactivate the child
lock function.
Turn off the delayed end function.
BOLERO DRESSCODE 8800 INVERTER A / INVERTER STEEL A / INVERTER ICE BLUE A
ENGLISH
115